Benchmark DAC-1 [复制链接]

leslie 在 2005-5-27 17:18:23 发表的内容
听台湾的一些同好说：Perpetual P3A比Benchmark DAC-1要好不少，价格又便宜：）有机会要一起比较下

另外对以下这台WEISS的评价也颇高[upload=jpg]Upload/200552717163155424.jpg[/upload]
转studioversion：
Features: Inputs:
There are three digital inputs on XLR connectors, and one on Toslink (optical). The accepted sampling frequencies are 44.1, 48, 88.2 and 96kHz. AES/EBU signals on a single connector are used. Each XLR input is actively routed to a corresponding XLR digital output, allowing monitoring at multiple stages in a digital studio setup.

Synchronization:
Several signal reclocking schemes are combined for extremely high jitter attenuation, making the DAC1 virtually immune to jitter over a very wide bandwidth.

Converters:
The correlation technique (using two converters per channel) which was already successfully employed in the ADC1 gives the DAC1 an edge over other D/A converters with equal wordlength and sampling rate specifications, resulting in improved SNR and THD.

Outputs:
The discrete Class A outputs have a virtually zero Ohm output impedance, but still can drive large loads without stability problems. Output levels can be set between -infinity and +27dBu. The outputs are symmetrical, but do not have any sound degrading servo mechanisms built in. For asymmetrical operation only one leg of the XLR connector (plus ground) is used.

Remote:
By hooking up an analog potentiometer or fader to the remote connector, the output level can be remote controlled. This level control happens in the digital domain. The input source selection can also be remote controlled.

Frontpanel Elements:
Four switches for input selection
Four LEDs for sampling frequency display (44.1 / 48 / 88.2 / 96)
Three LEDs for input wordlength display (1..16, 17..20, 21..24 bits)
One Emphasis LED
Two 25 turn trim potentiometers for fine trimming the output level


Backpanel Elements:
Three digital inputs on XLR
One digital input on Toslink
Three digital outputs on XLR, buffered from XLR inputs
Two analog outputs (channel 1,2) on XLR
Output level range switch (high / low) Remote connector with the following signals:
Power supply to external faders
Tapers from two external faders
four input selection switches
four LEDs for input selection switches

这是在台湾相当少见的瑞士Weiss DAC 1

如果说DAC数字声感太重

那您肯定没听过Weiss的DAC

Weiss的特点是温厚却不失解析

完成度一样很高的DAC

在家用市场并不多见....因为长相不够Hi-End的关系(不够美)

不过这是见人见智的东西

当然分辨率往上比是比不上DCS的955

不过......Weiss在国外pro studio Eng.的眼中是和Manley,Focusrite同等声音级数的东西

以上所言为同行前辈所言之大略
[upload=jpg]Upload/200552717172939544.jpg[/upload]

RAXEL兄了解否？