Wilmer威馬 在 2004-5-22 20:06:36 发表的内容
沒有。。。。。那些英文不明？ |
To adjust the height and levelness of the sub-chassis, arm board and platter the nuts at the bottom of the suspension bolts are rotated either to raise or lower it. By adjusting the nuts on the suspension bolts by differing amounts the suspension can be levelled. The height should be adjusted so that the arm board is brought level with the plinth and the platter level with the top plate with a gap of about 2-3mm equally all round. Check with a spirit level on the platter. Since the turntable support has been levelled, levelling the platter should result in an equal distance between the platter and the top plate all round. If you notice that the top plate is slightly warped in a downward fashion along the edge adjacent to the armboard, this is normal. The top plate is stressed when fitted into the wooden plinth, for better resonance control, and transmission of unwanted energy. You are now ready to set up the suspension.
